Creedy Carfume "Surge"

To get the best out of your Carfume and use it safely please follow these instructions carefully.

Please always prepare your Carfume™️ outside of the car on a clean, flat and wipe-clean surface before placing inside your car, wipe up any spillage immediately.

• Unscrew the cork from the Carfume™️ bottle and the lid from the refill bottle
• Squeeze all of the liquid from the refill bottle into your Carfume™️ bottle
• Screw the cork on the Carfume™️ bottle tightly and ensure it is fitted correctly and not loose
• Shake the bottle gently
• Hold the bottle upside down for 5-10 seconds until you see the tip of the cork begin to darken. DO NOT OVERSOAK
• Hang your Carfume™️ inside your vehicle from the rear view mirror (ensuring only the string is in contact with the interior of the car.*  Alternatively attach to the vents with our Vent Clips (sold separately).** 
• Repeat step 5 every 5-7 days to release the fragrance

• Only use your Carfume™️ for a maximum of 6 weeks. After 6 weeks of use, please remove your Carfume™️ from your vehicle to prevent leaking and either replace the cork with a new one or replace the entire Carfume™️.

Excessive inverting of bottle will oversoak the cork and may cause leaking | Any spillages should be cleaned immediately to avoid staining | Do not obstruct your view whilst driving | Liquid must not come into direct contact with any surfaces within the car or home

*No part of the bottle or cork, nor the liquid, should come into contact with the rear view mirror or any other car or home surface.

** Ensure that only the vent clip is in contact with the car interior and no part of the cork or bottle is touching any surface.

Oversoaking Cork can cause leaking | Any spillages should be cleaned immediately to avoid staining | Do not obstruct your view whilst driving

Please review our Terms and Conditions. We cannot be held responsible for failure to adhere to our instructions or misuse of our products.

• Your x2 Deluxe Fragrance Bars are inside your foil pouch
• Simply add the Fragrance Oil from your refill bottle, and leave to soak for a minimum of 10 minutes (the longer the soak, the stronger the strength) We recommend 24 hours
• Unscrew the end of your Deluxe Diffuser, and add one soaked Fragrance Bar into your diffuser. Screw the end cap back onto the Deluxe diffuser tightly.
• Ensure you open the vents of the Deluxe Diffuser by twisting the end cap to full strength.
• Add to a vent inside your car, turn up your heaters and Drive Happy!

Please review our Terms and Conditions. We cannot be held responsible for failure to adhere to our instructions or misuse of our products, nor for any leaks, spillages or damage when using our products. Use of this product is at your own risk.

Please handle your Carbear with care, these are a delicate item and will break if dropped or handled roughly.

• Remove Cap from fragrance bottle and apply a few drops of fragrance to your new bear
• Place Carbear in your car, using clip to attach securely to air vent.
• Repeat the above steps weekly.

Please always prepare your Carbear before placing inside your car and prepare your Carbear on a flat, wipe-clean surface. Wipe up any spillages immediately to prevent staining. Carbears are delicate so please handle carefully, we cannot be held responsible for damage caused by improper handling of them or damage arising from dropping them.

• Any spillages should be cleaned immediately to avoid staining
• Liquid must not come into direct contact with any surfaces within the car or home
• Refill bottle must be stored carefully in an upright position to prevent leaking – we do not recommend storing this inside the car

Please review our Terms and Conditions. We cannot be held responsible for failure to adhere to our instructions or misuse of our products, nor for any leaks, spillages or damage when using our products. Use of this product is at your own risk.

• Warning - Delicate item - Handle with care - Do not use excessive force.

• Turn the lid anti-clockwise to remove the lid.

• Fill water tank to ¾ level with fresh, cool water and leave for 5 minutes to allow the swab to soak up the water.

• Add a few drops of your chosen fragrance oil to the water tank.

• Replace the lid and turn in a clockwise direction until secured.

• Connect the USB cable.

• To operate the spray function, short press the button once for continuous spray mode, short press the button again for intermittent spray mode and short press the button a third time to switch off the spray function.

• To operate the rainbow light function, press and hold the button for two seconds, press and hold for two seconds a second time to activate the white light function. To switch off the light function press and hold the button a third time, for two seconds.

• The continuous spray function has an automatic switch off after 6 hours and the intermittent spray function has an automatic switch off after 12 hours. However, we do not recommend leaving your Mist unattended.

• It is important to rinse out the water tank after each use and to change the cotton swab monthly, or when using a new fragrance, whichever comes first.

• To change the cotton swab, remove the lid as above and pull to remove the plastic swab cover, replace swab and put the cover back on, before replacing the lid and operating as usual.

• To clean the unit please use a soft, dry cloth to avoid damaging the electrical components.

• DO NOT ADD UNDILUTED FRAGRANCE OIL TO THE UNIT, ALWAYS
• ENSURE THE WATER IS ADDED FIRST
• UNDILUTED FRAGRANCE OIL CAN CAUSE DAMAGE TO THE INTERNAL MECHANISM OF THE UNIT
• DELICATE ITEM, PLEASE HANDLE WITH CARE

WE HIGHLY RECOMMEND PREPARING YOUR MIST BEFORE PLACING INSIDE YOUR VEHICLE. PLEASE ONLY SWITCH ON OR ADJUST IT WHEN YOUR VEHICLE IS STATIONARY AND ENGINE IS SWITCHED OFF, IN ACCORDANCE WITH ROAD SAFETY LAWS.
PLEASE DO NOT LEAVE UNATTENDED WHEN IN USE
PLEASE DO NOT ALLOW CHILDREN TO OPERATE THE DEVICE
PLEASE DO NOT SWITCH ON, WITHOUT ADDING THE REQUIRED WATER
WIPE UP ANY SPILLAGES IMMEDIATELY
HANDLE THE UNIT WITH CARE AND DO NOT USE EXCESSIVE FORCE
 
Technical Information
Working voltage DC5 0V/1A
Working current 200-420mA
Use power 2w
Spray volume 45-50 ml/h
Water tank capacity 310ml
Net weight 165g
Product size 72 x 72 x 153mm
Product material ABS, Silicone and PP

Please review our Terms and Conditions. We cannot be held responsible for failure to adhere to our instructions or misuse of our products, nor for any leaks, spillages or damage when using our products. Use of this product is at your own risk.